This module was inspired by Make Noise „Pressure Points“, which has three rows of four tunable voltages. PUSH takes one of these rows in order to play melodies, change timbral settings of oscillators or even to store simple presets for a given parameter of any other module in an HP friendly design.
key features
Manual Sequential Switch
Four Voltages
Loop Sequence in 2, 3 or 4 Steps
Reset to Jump to Step 1
Variable Maximum Voltage via Trimmer Pot
LED Indicators
Wrong Polarity Protection
​
​specs & downloads
width: 4 HP
depth: 28 mm
power: 35 mA @ +12V / 30 mA @ -12V
videos
description / manual
PUSH is a single four position manual sequential switch. There are four steps, each with a potentiometer to set a specific voltage. With a push on the PUSH button one of these values is selected and supplied at the OUTPUT jack. The sequence always starts with the first step and you may switch through the other three potentiometer/voltages sequentially. The sequence will loop when you have reached the last step and press the button further more. ​
You can set the length of the sequence from 2 up to 4 steps. With the help of the RESET button you may jump to the first value at any given time.
Additionally you can simultaneously change the maximum voltage of all four steps from 5V to 10V with the help of the little trimmer pot VR on the top. You can choose to have any voltage between 5V and 10V. Turning the trimmer pot will instantly change the value for all four potentiometers.