ENVOLTURA boasts a highly responsive analog envelope with controls for ATTACK, DECAY, SUSTAIN, and RELEASE. When a gate signal is applied to the GATE input, the envelope is triggered, and a corresponding CV signal is produced at the OUT, with an inverted version available at the INV output.

Furthermore, an end-of-cycle GATE signal can be accessed from the EOC socket, which outputs a gate signal when the sustain phase of the envelope ends. The signal remains high until the start of the next attack phase. The gate is indicated by an LED. You have also the flexibility to retrigger the DECAY phase of the envelope by applying a trigger signal to the RTRG input.

IN addition to manual level adjustment via the slider level potentiometer, you can modulate the envelope's level using an internal VCA by patching a CV signal to the VEL input socket. An exclusive attenuator enables precise control over the level modulation.

For dynamic modulation, simply patch any CV source to the PUSH inputs and manipulate both the envelope's length and level. Fine-tune the overall length range with the SLOW/FAST switches, and if desired, activate the CYC switch to let the envelopes cycle within specific ranges. Please note that cycling may stop for very fast cycles and that the envelope doesn´t restart from 0 volts.

Finally, you can also trigger each envelope manually. Please note that both ADSRs are normalised to each other, so that pressing a button always triggers both envelopes, unless a patch cable is connected to the gate input of the other. ENVOLTURA QUICK START GUIDE: