Has anyone got any advice on the best way to solder the tactile switch (PTS820J15KPSMTRLFS) used in the IsiW ren and Klangmaschine builds? It doesn't easily lie flat due to a plastic knob on the bottom and then there is very little in the way of legs to solder to. Quite tricky.
If someone could attach me a photo showing how they soldered it, it would be much appreciated!
Hey mwmac, Apply flux paste on the pads, place the switch and then apply solder to the soldering lugs (where they touch the pads) with a tinned tip.
You can also omit these switches, the modules should work without them. Thanks, Stefan