Hello I bought the PUSH module but have been struggling to understand how it operates. I realize PUSH has one output only, but I'm not sure where it's meant to be connected to. Please help.
Hey Ryan,PUSH is a single four position manual sequential switch. There are four steps, each with a potentiometer to set a specific voltage. With a push on the PUSH button one of these values is selected and supplied at the OUTPUT jack. The sequence always starts with the first step and you may switch through the other three potentiometer/voltages sequentially. The sequence will loop when you have reached the last step and press the button further more.You can connect the output to any other CV input and manually sequence through the 4 voltage values to create parameter changes. You could change the filter cutoff frequency by toggling between the 4 PUSH CV values for example, or the speed of an LFO, delay time of delay effect, harmonics of an oscillator etc. The possibilities here are actually endless.Cheers,Stefan
Hey Ryan, PUSH is a single four position manual sequential switch. There are four steps, each with a potentiometer to set a specific voltage. With a push on the PUSH button one of these values is selected and supplied at the OUTPUT jack. The sequence always starts with the first step and you may switch through the other three potentiometer/voltages sequentially. The sequence will loop when you have reached the last step and press the button further more. You can connect the output to any other CV input and manually sequence through the 4 voltage values to create parameter changes. You could change the filter cutoff frequency by toggling between the 4 PUSH CV values for example, or the speed of an LFO, delay time of delay effect, harmonics of an oscillator etc. The possibilities here are actually endless. Cheers, Stefan