Hi! I want to use the Sum Main module as my output module since it's great for that, I mean it has everything I need. But also want to connect one or two modules as mastering modules after the mixer and still be able to hear the processed sound in my headphones. Are there any points on the PCB where I could create an insert point? My idea would be to connect a few cables to a second panel with contacts for in and outs. Any help or input is appreaciated <3
top of page
bottom of page
Hello Kork,
To achieve the playback of the processed sound from external effects in both the headphones and the main output of the Stereo Sum Main Module, you'll need to interrupt the input to the main module (MIX_R_BUS and MIX_L_BUS) that goes to Pin 2 and 6 of U1. Then, reroute it to the external effects and reintroduce it with a resistor of approximately 100k (one for each) to the previously mentioned pins. This way, you'll have the wet signal on both the headphones and the main output, while the dry signal remains in the AFL signal path for comparison. However, I have never tested this before and cannot guarantee that it will work.
If you're interested, I can send you the schematics for your reference.
Best,
Stefan