Does anyone know the calibration procedure for the reverb module? There are two trimmers. One named "Gain" and the other named "Attin". What do these trimmers control? Thanks in advance. I couldn't seem to locate the information on the BOM or other supporting files.
top of page
bottom of page
Hey Brian,
I added this information to the BOM: ATTIN - Adjust the input signal level by turning the control knob to the right until you reach the point just before the signal starts to distort.
OUTGAIN - Adjust the output signal gain by turning the control knob to the right until you reach the point just before the signal starts to distort.
It is crucial to adjust the output gain proportionately when modifying the input level, as changes to one directly impact the other. Cheers,
Stefan