When soldering the LM4040 on the DUCK main board, I first soldered the single pin side
Then when soldering another pin on the two pin side, the LM4040 got angled so I tried pushing it back in place carefully but it immediately came off and now to solder pads are gone on two pins.
Where do these pins connect to other components so I can use wires to solder the LM4040 to these?
Awesome, thank you :)
Hey Christian, Sorry for my late reply, I must have overlooked your post. Only two pins are connected, please refer to the picture below:
Hope this helps.
Cheers,
Stefan